Max Systems LabelMax XS Manual de Serviço descarregar pdf (Página 84)

Unit 5: Adjustment Procedures

Page 5-4 SATO D508/D512 Service Manual

PRINT DARKNESS

A fine adjustment for PRINT DARKNESS can be made using potentiometer VR1 on the Front

Operator Panel. It provides a continuous range of adjustment, allowing you to make precise

changes. Turning VR1 clockwise will make the print darker, and counterclockwise will make it

lighter.

1 Place DSW6 on the Configuration Switch in the ON position.

2 Turn the Power Switch OFF.

3 While pressing the FEED button on the Operator Panel, turn the Power Switch ON.

4 When you hear one beep from the printer, release the FEED button.

5 Press the LINE button to begin printing large Test Labels (press the FEED button if you are

using labels smaller than 4.1" (104 mm) in width).

6 Adjust potentiometer VR1 until the desired print darkness is obtained.

7 Press the FEED button to stop the printing.

Adjustment of the Print Darkness using VR1 will affect the darkness in all the <ESC>#E

command code ranges; that is, if the print darkness is adjusted with VR1 for lighter print, the

darkness will be lighter in all the Print Darkness ranges selected by the command code.

Figure 5-1, Test Panel

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 90

Sem comentários

Max Systems LabelMax XS Manual de Serviço Página 84